A couple notes before you get started:
- Make sure Raspberry Pi is powered off when connecting wires.
- When using a GPIO ribbon cable, make sure the power wire (it’s a different color than the others) is connected to the corner of your Raspberry Pi and the top of your Pi cobbler.
- The provided diagram is just an example of how to connect the sensor. There are many ways to connect sensors and extensions, so try what works best for you!
- Some full-size breadboards (used in diagrams below) have a powerline that is separated in the middle. If this is the case, be sure your sensors are connected on the same half of the breadboard as your Pi Cobbler.